Whirlpool Duet Dryer Won T Start Just Clicks. Push the button in on the door switch with one meter probe on com and the other meter probe on no and see if it reads. (possible causes & fixes from upgradedhome.com.
The control panel lights up (with no codes) but when the start button is pressed i hear a click and nothing happens. Make sure your dryer is unplugged! Without a meter is is difficult to determine why the dryer will not start.
Table of Contents
It Is Not Likely The Belt Broke But The Thermal Fuse Is Certainly A Possibility And I Am Including In The Images Below How To Access And Check The Thermal Fuse On Most Whirlpool Duet Dryers.
Try to press the start button and listen closely to your dryer. Pushed it a few more times to make sure. So while you may have pressed the start button, it won’t start for a little longer.
When A Whirlpool Dryer Won’t Start But Has Power, The Cause Is Usually The Thermal Fuse, The Start Switch, The Door Switch, Or The Belt Switch.
Make sure your dryer is unplugged! If the dryer is not level, the sensing does not work properly, and your drying cycle will end early. Reassembled the dryer and works fine.
Unplug The Dryer And Look In The Bottom Front Left Corner.
Whirlpool duet dryer won t start just clicks. Most whirlpool dryers require holding the start button for two seconds before the cycle begins. Just as a precaution i am going to seal this with some tape and put a towel on top.
If You Can’t Heat A Thing, This May Mean That The Dryer Is Not “Receiving” The Command For Starting.
The door switch was not ‘clicking’, it would push in and go out but no click. The thermal fuse is a safety device designed to stop the dryer from catching fire. Duet or not, if your washing machine is not getting started, it is a frustrating and disappointing moment.
To Access The Start Relay In The Console, Remove The Screws On The Back Of The End Caps Of The Console And You Can Then Lift It Off Of The Top Panel (With The Dryer Still.
Some of them are drum belt broken, idler pulley broken, thermal fuse blown Several factors may cause your whirlpool duet dryer not to start. If the thermal fuse is okay, you could have a bad start relay even though it is clicking.